Aztech 604EU
Modem Status
Connection Status Connected
Us Rate (Kbps) 800
Ds Rate (Kbps) 5056
US Margin 10
DS Margin 23
Trained Modulation ADSL_G.dmt
LOS Errors 0
DS Line Attenuation 19
US Line Attenuation 13
Peak Cell Rate 1886 cells per sec
CRC Rx Fast 0
CRC Tx Fast 1
CRC Rx Interleaved 0
CRC Tx Interleaved 0
Path Mode Fast Path
DSL Statistics
Near End F4 Loop Back Count 0
Near End F5 Loop Back Count 0
DSL UP
Downstream / Upstream (Kbps) 5056/800
Internet Connected
Connected Time 8hr 46min 41sec
Connection Type PPPoE
Username
XXXXXXXX@teksavvy.com IP Address 206.248.177.163
Default Gateway HI.DD.EN.IP
Primary DNS HI.DD.EN.IP
Secondary DNS HI.DD.EN.IP
SN Margin (AKA Signal to Noise Margin or Signal to Noise Ratio) Relative strength of the DSL signal to Noise ratio: 6dB is the lowest dB manufactures specify for modem to be able to synch. In some instances interleaving can help raise the noise margin to an acceptable level. The higher the number the better for this measurement.
6dB or below is bad and will experience no synch or intermittent synch problems
7dB-10dB is fair but does not leave much room for variances in conditions
11dB-20dB is good with no synch problems
20dB-28dB is excellent
29dB or above is outstanding
Line Attenuation
Measure of how much the signal has degraded between the DSLAM and the modem: maximum signal loss recommendation is usually about 60dB. The lower the dB the better for this measurement.
20dB and below is outstanding
20dB-30dB is excellent
30dB-40dB is very good
40dB-50dB is good
50dB-60dB is poor and may experience connectivity issues
60dB or above is bad and will experience connectivity issues
